References

Gologlu, C. and N. Sakarya, 2008. The effects of cutter path strategies on surface roughness of pocket milling of 1.2738 steel based on Taguchi method. J. Mater. Process. Technol., 206: 7-15.
CrossRef  |  Direct Link  |  

Jamil, A.T.M., 1998. A semi-analytical method of finding an optimum cutter path for face milling 3-sided convex surfaces. Intl. J. Prod. Res., 36: 343-355.
Direct Link  |  

Lakkaraju, R. and S. Raman, 1990. Optimal NC path planning: Is it really possible?. Comput. Ind. Eng., 19: 462-464.
CrossRef  |  Direct Link  |  

Monreal, M. and C.A. Rodriguez, 2003. Influence of tool path strategy on the cycle time of high-speed milling. Comput. Aided Des., 35: 395-401.
CrossRef  |  Direct Link  |  

Prabhu, P.V., A.K. Gramopadhye and H.P. Wang, 1990. A general mathematical model for optimizing NC tool path for face milling of flat convex polygonal surfaces. Intl. J. Prod. Res., 28: 101-130.
Direct Link  |  

Quinsat, Y. and L. Sabourin, 2007. Optimal selection of machining direction for three-axis milling of sculptured parts. Intl. J. Adv. Manuf. Technol., 33: 684-692.
Direct Link  |  

Ramos, A.M., C. Relvas and J.A. Simoes, 2003. The influence of finishing milling strategies on texture, roughness and dimensional deviations on the machining of complex surfaces. J. Mater. Process. Technol., 136: 209-216.
CrossRef  |  Direct Link  |  

Toh, C.K., 2006. Cutter path orientations when high-speed finish milling inclined hardened steel. Intl. J. Adv. Manuf. Technol., 27: 473-480.
Direct Link  |  

Wang, H., H. Chang, R.A. Wysk and A. Chandawarkar, 1987. On the efficiency of NC tool path planning for face milling operations. J. Eng. Ind., 109: 370-376.
CrossRef  |  Direct Link  |  

Xiao, K.Q. and L.C. Zhang, 2002. The role of viscous deformation in the machining of polymers. Int. J. Mechanical Sci., 44: 2317-2336.
Direct Link  |