References

Abdulhadi, H., S. Ahmad, I. Ismail, M. Ishak and G. Mohammed, 2017. Experimental investigation of thermal fatigue die casting dies by using response surface modelling. Met., 7: 1-13.
CrossRef  |  Direct Link  |  

Abdulhadi, H., S. Ahmad, I. Ismail, M. Ishak and G. Mohammed, 2017. Thermally-induced crack evaluation in h13 tool steel. Met., 7: 1-11.
CrossRef  |  Direct Link  |  

Ali, N.B., R. Estevez and D. Tanguy, 2013. Heterogeneity of grain boundaries in 5xxx and 7xxx Aluminum alloys and its influence on intergranular toughness. Eng. Fract. Mech., 97: 1-11.
CrossRef  |  Direct Link  |  

Aryslanova, E.M., A.V. Alfimov and S.A. Chivilikhin, 2015. Modelling the growth process of porous Aluminum oxide film during anodization. J. Phys. Conf. Ser., 643: 1-4.
CrossRef  |  Direct Link  |  

Bensalah, W., K. Elleuch, M. Feki, M. Wery and H.F. Ayedi, 2007. Optimization of anodic layer properties on aluminium in mixed oxalic/sulphuric acid bath using statistical experimental methods. Surf. Coat. Technol., 201: 7855-7864.
CrossRef  |  Direct Link  |  

Bensalah, W., K. Elleuch, M. Feki, M. Wery and M.P. Gigandet et al., 2008. Optimization of mechanical and chemical properties of sulphuric anodized aluminium using statistical experimental methods. Mater. Chem. Phys., 108: 296-305.
CrossRef  |  Direct Link  |  

Bensalah, W., M. Feki, M. Wery and H.F. Ayedi, 2010. Thick and dense Anodic oxide layers formed on aluminum in sulphuric acid bath. J. Mater. Sci. Technol., 26: 113-118.
CrossRef  |  Direct Link  |  

Byeon, S.G. and Y. Tzeng, 1988. Improved oxide properties by anodization of Aluminum films with thin sputtered Aluminum oxide overlays. J. Electrochem. Soc., 135: 2452-2458.
CrossRef  |  Direct Link  |  

Habib, K., W. Mohammad, F. Karim and J. Dutta, 2017. Resistance values of Aluminum oxide film in situ during anodization of Aluminum by Fabry-Perot interferometry. ECS. Trans., 80: 1221-1229.
CrossRef  |  Direct Link  |  

Hull, M.J. and J.L. Abraham, 2002. Aluminum welding fume-induced pneumoconiosis. Hum. Pathol., 33: 819-825.
PubMed  |  Direct Link  |  

Kikuchi, A., 1985. Lowering of initial anodizing current density due to thin Aluminum oxide film on evaporated Aluminum. Jpn. J. Appl. Phys., 24: L45-L46.
Direct Link  |  

Konieczny, J., K. Labisz, J. Wieczorek and L.A. Dobrzanski, 2008. Stereometry specification and properties of anodization surface of casting Aluminium alloys. Arch. Mater. Sci., 33: 13-20.
Direct Link  |  

Wen, W., Y. Zhao and J.G. Morris, 2005. The effect of Mg precipitation on the mechanical properties of 5xxx aluminum alloys. Mater. Sci. Eng. A., 392: 136-144.
CrossRef  |  Direct Link  |