References

Cadirli, E., 2013. Effect of solidification parameters on mechanical properties of directionally solidified Al-rich Al-Cu alloys. Met. Mater. Intl., 19: 411-422.
Direct Link  |  

Cadirli, E., N. Marasli and B. Bayender, 1999. Investigation of the structure parameters according to the solidification parameters for pivalic acid. J. Mater. Sci., 34: 5533-5541.
Direct Link  |  

Cadırli, E., N. Marasli, B. Bayender and M. Gunduz, 2000. Dependency of the microstructure parameters on the solidification parameters for camphene. Mater. Res. Bull., 35: 985-995.
Direct Link  |  

Carvalho, D.B., E.C. Guimaraes, A.L. Moreira, D.J. Moutinho and J.M.D. Filho et al., 2013. Characterization of the Al-3wt.% Si alloy in unsteady-state horizontal directional solidification. Mater. Res., 16: 874-883.
Direct Link  |  

Costa, T.A., E.S. Freitas, M. Dias, C. Brito and N. Cheung et al., 2015. Monotectic Al-Bi-Sn alloys directionally solidified: Effects of Bi content, growth rate and cooling rate on the micro structural evolution and hardness. J. Alloys Compd., 653: 243-254.
Direct Link  |  

Engin, S., U. Buyuk and N. Marasli, 2016. The effects of microstructure and growth rate on micro hardness, tensile strength and electrical resistivity for directionally solidified Al-Ni-Fe alloys. J. Alloys Compd., 660: 23-31.
Direct Link  |  

Ferreira, I.L., D.J. Moutinho, L.G. Gomes, O.L. Rocha and A. Garcia, 2009. Modeling and experimental analysis of macro segregation during transient solidification of a ternary Al-6wt% Cu-1wt% Si alloy. Philos. Mag. Lett., 89: 769-777.
Direct Link  |  

Grugel, R.N., 1995. Microstructural evolution of primary dendrite trunks in directionally solidified, hypoeutectic, Aluminum-Silicon alloys. Metall. Mater. Trans. A, 26: 496-499.
Direct Link  |  

Gunduz, M. and E. Cadirli, 2002. Directional solidification of aluminium-Copper alloys. Mater. Sci. Eng. A, 327: 167-185.
Direct Link  |  

Karakose, E. and M. Keskin, 2011. Structural investigations of mechanical properties of Al based rapidly solidified alloys. Mater. Des., 32: 4970-4979.
Direct Link  |  

Kaya, H., E. Cadirli, U. Boyuk and N. Marasli, 2008. Variation of micro indentation hardness with solidification and microstructure parameters in the Al based alloys. Appl. Surf. Sci., 255: 3071-3078.
Direct Link  |  

Lin, X., W. Huang, J. Feng, T. Li and Y. Zhou, 1999. History-dependent selection of primary cellular/dendritic spacing during unidirectional solidification in Aluminum alloys. Acta Mater., 47: 3271-3280.
Direct Link  |  

Mohamed, A.M.A. and F.H. Samuel, 2012. Influence of Mg and solution heat treatment on the occurrence of incipient melting in Al-Si-Cu-Mg cast alloys. Mater. Sci. Eng. A, 543: 22-34.
Direct Link  |  

Osorio, W.R., J.E. Spinelli, I.L. Ferreira and A. Garcia, 2007. The roles of macro segregation and of dendritic array spacings on the electrochemical behavior of an Al-4.5 wt.% Cu alloy. Electrochim. Acta, 52: 3265-3273.
Direct Link  |  

Quaresma, J.M., C.A. Santos and A. Garcia, 2000. Correlation between unsteady-state solidification conditions, dendrite spacings and mechanical properties of Al-Cu alloys. Metall. Mater. Trans. A, 31: 3167-3178.
Direct Link  |  

Rocha, O.L., C.A. Siqueira and A. Garcia, 2003. Heat flow parameters affecting dendrite spacings during unsteady-state solidification of Sn-Pb and Al-Cu alloys. Metall. Mater. Trans. A, 34: 995-1006.
Direct Link  |  

Samuel, A.M., H.W. Doty, S. Valtierra and F.H. Samuel, 2014. Relationship between tensile and impact properties in Al-Si-Cu-Mg cast alloys and their fracture mechanisms. Mater. Des., 53: 938-946.
Direct Link  |  

Sjolander, E. and S. Seifeddine, 2010. The heat treatment of Al-Si-Cu-Mg casting alloys. J. Mater. Process. Technol., 210: 1249-1259.
Direct Link  |  

Tewari, S.N. and R. Shah, 1996. Macro segregation during dendritic arrayed growth of hypoeutectic Pb-Sn alloys: Influence of primary arm spacing and mushy zone length. Metall. Mater. Trans. A, 27: 1353-1362.
Direct Link  |